For Machines Mfg. Since 8/09 | P R E P A R A T I O N | Model SB1021/SB1022 |
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Note: Refer to Troubleshooting on Page 38 for solutions to common problems that occur with all metal bandsaws. If you need additional help, contact our Tech Support at (360)
To reduce the risk of serious injury when using this machine, read and understand this entire manual before beginning any operations.
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take required safety precautions, and make sure the machine is set up and adjusted properly
2.Clear away all tools and objects used during assembly and preparation.
3.Make sure the blade is properly tensioned and the blade guides are positioned correctly (for detailed instructions, refer to Blade Tensioning on Page 23, and Adjusting Blade Guides on Page 26).
4.Connect the machine to the power source.
5.Push the ON button. The green motor light will illuminate and the motor will start.
6.Verify that the machine is operating correctly. When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.
Note: For three
ssIf the blade is moving in the upward direction out of the table, stop the machine immediately. It is likely wired "out of phase." To correct this problem, disconnect the machine from the power source, and switch any two incoming power wires at the main terminal block (refer to Figure 50 on Page 48).
7.Adjust the blade speed through the full range of operation. The speed should change as you make the adjustments.
8.Press the STOP button, the green motor light will go out, and the bandsaw will stop.
9.Turn the work lamp and the welding lamp ON and OFF.
10.Turn the grinder ON and OFF.
