| P R E P A R A T I O N |
|
13" Heavy 13® Gearhead Lathe | For Machines Mfg. Since 5/11 | |
|
|
|
5.Make sure the power cord and wires have slack between the strain relief and terminal connections so that they do not bind, then tighten the strain relief to secure the cord.
Note: The strain relief must be tightened against the outer jacket of the cord. Avoid over- tightening the strain relief or it may crush the cord and cause a short.
6.Test the strain relief to ensure it is properly tightened by pulling the cord from outside the box with
7.Install a NEMA
8.Close and lock the main electrical box door.
9.Connect the plug to the matching receptacle and power source as specified in Circuit Requirements on Page 17.
To avoid unexpected
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, shut the machine down, disconnect it from power, and do not operate it until you have resolved the problem.
A Troubleshooting section is provided, starting on Page 84, to assist you with solutions if a problem occurs or if the lathe does not function as described in this section.
If you need additional help after reviewing the troubleshooting section, or you are not confident troubleshooting the machine on your own, contact our Tech Support at (360)
To test run your machine:
1.Make sure the master power switch (see Figure 22) on the rear of the machine is turned OFF.
Main Power
Switch
Figure 22. Location of the master power switch.
2.Read and follow the safety instructions at the beginning of the manual, take all required safety precautions, and make sure all previous preparation steps discussed in this manual have been followed and completed.
