SOYO SY-6ZB manual IDE Device Installation HDD, CD-ROM, Floppy Drive Installation

Hardware Setup SY-6ZB

Step 4. IDE Device Installation (HDD, CD-ROM)

This Motherboard offers two primary and secondary IDE device connectors (IDE1, IDE2.) It can support up to four high-speed HDD or CD-ROM.

Connect one side of the 40-pin flat cable to the IDE device (HDD or CD-ROM) and plug the other end to the primary (IDE1) or secondary (IDE2) directionally keyed IDE connector on the Motherboard.

This Motherboard can support up to four HDDs.

Step 5. Floppy Drive Installation

The system supports 5 possible floppy drive types: 720 KB, 1.2 MB,

1.44MB, 2.88 MB, and LS-120. In addition, this Motherboard supports a 3-mode (720KB/1.2MB/1.44MB) floppy commonly used in Japan.

Connect one side of the 34-pin flat cable to the floppy drive and plug the other end to the floppy drive connector on the Motherboard. This Motherboard can support up to 2 floppy drives.

Step 6. Front Panel Connections

ResetS	+	Power
	_
O		LED
I
B		Key
PWRBT
h		Lock
s
a	+
Turbo +
l
_
LED F

HDD +		SPEAKER
LED _	_

®

Ultra

®

®

13