Spalding M5800041 manual scrap wood Not Supplied, Fig A, alignment mark

IMPORTANT!

ONCE POLE SECTIONS ARE POUNDED TOGETHER- THEY CANNOT BE TAKEN APART

2. Align poles using alignment marks. First, pound top and middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG A. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way.

CAUTION!

THE IDENTIFICATION STICKER IS

LOCATED 3-3/4" FROM THE END OF

THE POLE. WHEN PROPERLY

POUNDED TOGETHER, THE POLE

SECTIONS SHOULD HAVE A 2-1/2"

MINIMUM OVERLAP, LEAVING 1-1/4"

BETWEEN THE OVERLAPPING POLE

AND THE IDENTIFICATION STICKER.

alignment mark

TOP

2

alignment mark

MIDDLE

FIG A.

scrap wood (Not Supplied)

IDENTIFICATION

STICKER

middle pole

3-1/2”

3

alignment mark

BOTTOM

IDENTIFICATION
STICKER	1-1/4"
	middle pole

4

ID# M5800041 01/06 8