Spalding M661154 manual Pole Sections should have a 3-1/2 9 CM Minimum Overlap

3.Align dimple of middle pole with slot of bottom pole.While maintaining alignment, bounce top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no longer move toward pole identification mark.

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2" MINIMUM OVERLAP, LEAVING 1-1/2"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

5"

Bottom Pole

IDENTIFICATION

STICKER

NOTE:

POLE SECTIONS SHOULD HAVE A 3-1/2" (9 CM)

MINIMUM

OVERLAP.

POLE

IDENTIFICATION

MARK

1

2

3

IDENTIFICATION	1-1/2"
	Bottom Pole
STICKER

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

IMPORTANT!

WOOD SCRAP

(NOT SUPPLIED)

Holes in top (1) and bottom (3) pole sections MUST align to correctly position elevator system toward playing surface.

ID# M601114 8/05 10