The Z-braneis a revolutionary product which incorporates the Z-Guard High Voltage Capacitive technology into the membrane pressure vessel. Always active, the Z-Brane creates an environment that is unfriendly to bio-film and bacteria. The Z technoalgy also assits in the prevention of scale formation on the membrane surfaces. The Z-Brane allows the system to be shut down or decommissioned for extended periods of time without chemicals or preservatives. The Z-Brane will not prevent freezing so that in cold climates Propylene Glycol is still required.
The Z-Brane system is integral with the watermaker unit and only requires continuous 12Vor 24V DC power to be operative. The installation of the Z-Brane only consists of wiring the power supply to a continuous source The Z-brane power supply can tolerate voltages between 10V and 28V DC.
Note: There is no reason to open the transformer enclosure. Do not ser- vice this unit without disconnecting the power source! There may be high voltage present.
It is recommended that the Z-Brane be connected to a discreet continuous power source. The power must be on during the time that the system is operation and during the time the Z-Brane is used for membrane storage. If the power is obtained from the MPC then the MPC must be powered up at all times during storage. This may not be desirable.
Fuse the power at the source with a 5 amp fuse or circuit breaker.
Red is Positive (+) , Black is Ground (-)
Z-Brane Power Harness
