SpectraLink e340, h340, i640 - page 41

SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide

Part Number: 72-1004-01-F.doc Page 41

Feature activation 1. Press the Start Call button followed by the MENU key. The

Pre-dial labels and corresponding shortcut codes are

displayed.

2. Navigate the list using the side Up and Down buttons. The

list is circular. Alternatively, the MENU button may be

pressed repeatedly to display the next set of four options.

3. Select the feature by pressing the OK soft key. Alternatively,

press the Select button or dial the shortcut, if available. The

handset then sends the programmed codes to the PBX.

4. The Exit soft key or End Call key can be used to terminate

prior to making a feature selection.

5. There is a ten second timeout which will return the handset

to the previous state if no additional keys are pressed while

in either Pre-dial menu or pre-dial mode.

6. The PBX could automatically release the call in some cases.

In this case the handset returns to the Standby mode.

7. There is a ten second timeout which will return the handset

to the previous state if no additional keys are pressed while

in the Post-dial menu.

Contents

Main Notice Trademark Information Table of Contents NetLink e340/h340/i640 Wireless Telephone Accessories 19 General Care of the Handsets and Chargers 35 Tips For Use 36 Appendix A: Cisco SCCP Protocol 37 Appendix B: ITU H.323 Protocol 40 The NetLink e340 Wireless Telephone The NetLink h340 Wireless Telephone The NetLink i640 Wireless Telephone Operating Instructions Status Indicators Modes of Operation Basic Operation The Wireless Telephone Headset System Feature Activation Using the Softkeys Setting User Preferences When the handset is in standby mode (on but not in use), press and Navigation Lock keys Ring options Phone options System info Extension If PTT is allowed in the Admin menu and enabled by the user, Push-to-talk (PTT) Push-to-talk operation Page Page NetLink e340/h340/i640 Wireless Telephone Accessories Only the SRP protocol used with the NetLink Telephony Gateway is supported on The NetLink Docking Station Page Page Page Page Page Page Page Battery Packs Important NetLink Desktop Chargers NetLink Dual Chargers charging progress. The handset NetLink Quad Chargers Page Important Notes about Chargers and Battery Packs General Care of the Handsets and Chargers Tips For Use PLEASE NOTE: Appendix A: Cisco SCCP Protocol Cisco IP Phone 7960 phone type emulated by the NetLink Wireless Telephone Page Page Appendix B: ITU H.323 Protocol Page Appendix C: MGCP Protocol Appendix D: Mitel Networks Page Page Appendix E: SIP (Session Initiation Protocol) Basic Operation Page Safety and Regulatory Information NOTE CONCERNING THE WIRELESS TELEPHONES OPERATIONAL WARNINGS ELECTRO MAGNETIC INTERFERENCE/COMPATIBILITY Facilities Medical Devices Hearing Aids INTERNATIONAL CERTIFICATIONS: SPECIFIC ABSORPTION RATE (SAR) INFORMATION: