Spirit XE400 owner manual Handlebar Assembly

STEP 2: Handlebar Assembly

1.Install the two 17m/m Wave Washers (103) onto the Left and Right side of the Handle Bar axle.

2.Slide the Left (10) and Right (11) Handle Bars onto the appropriate side of the axle. The handlebars have a small sticker on them indicating L (left) and R (right).

3.Install two 3/8 X 30mm Flat Washers (99) onto the two 3/8￿ X 3/4￿ Hex Head Bolts (123) and install, and tighten, in the threaded holes in the ends of the axle.

4.Connect the two wires on the L&R sides together and store the excess, including plastic connectors, back into the console mast. Place the rubber grommets (145) over the wire and snap it into the hole in the console mast. Install the Front Handle Bar Covers (68 left, 69 right) and Rear Handle Bar Covers (68-1 left, 69-1 right) over the Handle Bar axle connections with the six 3.5x10m/m Self Tapping Screws (107).

	147
10	145
	68
123			146	147
99	103			145
107	146	12		103	69
	68-1

107

99

123

69-1 11

11 XE Series Elliptical