8.10 OPTIONAL CMP25 ENHANCED RAM+ SECOND STATION MIC OR VH-310 HANDSET INSTALLATION

The GX5500S is capable of using a CMP25 Enhanced RAM+ mic or VH-310Handset to remotely control the Radio, DSC and PA/Fog functions. In addition the GX5500S can operate as a full function intercom system.

1.Connect the Extension Cable to the Remote Mic eight pin connector on the rear panel, then tighten the Cable Nut (See Figure 3).

2.Referring to Figure 3, make a 1.2” (30 mm) hole in the wall, then insert the Extension Cable into this hole. Connect the Gasket and Mount Base to the Extension Cable Connector using the Nut.

3.Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mount- ing Base to the wall using four screws.

4.Put the Rubber Cap on to the Nut. The installation is now complete.

NOTE

The routing cable can be cut and spliced, however care needs to be taken when reconnecting the wires to ensure water integrity.

Before cutting the cable make sure it is not plugged into the radio. After cutting you will notice there are the following wires:

Yellow, Green, Brown, Purple, Blue, Green, RedÚ, ShieldÚ

ÚThe red and shield wires are wrapped in foil. Remove the foil, and seperate the Red and shield wires.

External Speaker Connections

Gasket

Cap

Wall

Routing Cable

Mounting Bracket

Nut

Figure 3. Enhanced RAM+ MIC Installation

Page 16

 

GX5500S