Standard Horizon Gx5500s M-SCAN, 10.13.3 Priority Scanning (P-SCAN), P-SCAN, CLR, SQL, MEM, MEM, MEM, MEM, CLR, SCAN, 16/9, SCAN, 16/9, CHANNEL, GX5500S, 12.8 SCAN RESUME TIME

5. To start scanning, press the [F] key followed by the [3(SCAN)] key, “M-SCAN” appears on the LCD. Scanning will pro- ceed from the lowest to the highest programmed channel number and will stop on a channel when a transmission is received.

6.The channel number will blink during reception.

7.To stop scanning, press the [CLR], [16/9], or [WX] key.

10.13.3 Priority Scanning (P-SCAN)

In the default setting, Channel 16 is set as the priority channel. You may change the priority channel to the desired channel from the Channel 16 by the Radio Setup Mode, refer to section “10.13.1 Selecting the Scan Type,” and “12.6

PRIORITY CHANNEL SET.”

1.Adjust the SQL knob until background noise disappears.

2.Select a desired channel to be scanned using the CHANNEL selector knob.

Press the [F] key followed by the [2(MEM)] key, “MEM” will appear on the display which indicates the channel has been programmed into the transceivers memory.

3.Repeat step 2 for all the desired channels to be scanned.

4.To DELETE a channel from the transceiver’s memory, select the channel then press the [F] key followed by the [2(MEM)] key, “MEM” is removed from the display.

5.To start priority scanning, press the [F] key followed by the [3(SCAN)] key.

“P-SCAN” appears on the LCD. Scanning will proceed between the memorized channels and the priority channel. The priority channel will be scanned after each programmed channel.

6. To stop scanning, press the [CLR], [16/9], or [WX] key.

You may change the scan resume time in the Radio Setup Mode, refer to section “12.8 SCAN RESUME TIME.”

Page 30 GX5500S