10.3 TRANSMISSION

1.Perform steps 1 through 6 of RECEPTION.

2.Before transmitting, monitor the channel to ensure it is clear.

THIS IS AN FCC REQUIREMENT!

3.Press the PTT (push-to-talk) switch. The “ ” indicator on the LCD is displayed.

4.Speak slowly and clearly into the microphone.

5.When the transmission is finished, release the PTT switch.

NOTE

This is a noise-canceling microphone. Position the Oval Slot label “MIC” within 1 inch (2.5 cm) from the mouth for optimum performance.

10.4 TRANSMIT TIME - OUT TIMER (TOT)

When the PTT switch on the microphone is held down, transmit time is limited to 5 minutes. This limits unintentional transmissions due to a stuck microphone. About 10 seconds before automatic transmitter shutdown, a warning beep will be heard from the speaker(s). The transceiver will automatically go to receive mode, even if the PTT switch is continually held down. Before transmitting again, the PTT switch must first be released and then pressed again.

10.5 SIMPLEX/DUPLEX CHANNEL USE

Refer to the VHF MARINE CHANNEL CHART (page 91) for instructions on use of simplex and duplex channels.

NOTE

All channels are factory-programmed in accordance with FCC (USA), Industry Canada (Canada), and International regulations. Mode of operation cannot be altered from simplex to duplex or vice-versa.

10.6 USA, CANADA, AND INTERNATIONAL MODE

1.To change the modes, hold the [16/9] key and press the [WX] key. The mode changes from USA to International to Canadian with each press of the [WX] key.

2.“USA” will be displayed on the LCD for USA mode, “INTL” will be dis- played for International mode, and “CAN” will be displayed for Canadian mode.

3.Refer to the VHF MARINE CHANNEL CHART (page 91) for allocated chan- nels in each mode.

GX5500S

 

Page 25