10 ► EPX10 User Manual
Voltage...............................................................................................................................................................................36 V DC
Number of Brazes (Per Charge) ..................................................................................................................................................50
Weight (incl. Battery) ............................................................................................................................................... 9.8 kg / 21.6 lb
Width .................................................................................................................................................................. 5.9 inch / 150 mm
Height ................................................................................................................................................................11.0 inch / 280 mm
Length............................................................................................................................................................... 12.5 inch / 320 mm
Temperature Range ........................................................................................................................-4° F - 130° F / -20° C - 55° C
EQUIPMENT
- Always make sure the batteries are fully charged.
- Check the cables from time to time for damage.
- Check the contact surface on the ground magnet from time to time to ensure a good connection.
- Make sure that the brazing pin with the ferule passes easily in the gun, centered.
BRAZING PINS AND FERRULES
-Keep them dry.
RAILBONDS AND CABLE LUGS
-Keep them free from oxidation.
-Keep them free from contamination like: Grease, oil.
-Make sure they are not damaged.
SETTING RIGHT LIFT HEIGHT
The S15 brazing gun self adjust to the same lift height every time.
See separate instructions in the maintenance section if adjustment for the gun is necessary.
PIN HOLDERS
Squeeze the ngers on the pin holder together each time you feel that the brazing pin goes in too easy when
mounting them into the pin holder. This is important since all the current goes thru the pin holder to the
brazing pin. If the ngers are too loose the pin holder will be damaged and must be replaced.

MAINTENANCE

SPECIFICATIONS

SPECIFICATIONS
EPX10 Econect Battery Kit (For Units S/N 1215091 and Up) ..........................................................................................73077
EPX10 Econect Battery Kit (For Units S/N 1215090 and Below) ......................................................................................73720