Stanley Black & Decker EPX10 Special functions:

EPX10 User Manual ◄ 11

Replace the fuses:

Push and unscrew counter-clockwise to remove fuse holder.

Replace fuse and re-install the fuse holder.

NOTE!

Control: 5A fuse.

Grinder: 15A fuse.

Special functions:

1. BATTERY INDICATOR:

Press and hold the “SETTING” button, while you push the “ON / OFF” button.

“LOW BATTERY” LED will light. Release the buttons.

The LEDs on the front panel show the charge status of battery.

2. LIFTING HEIGHT CONTROL:

First follow step 1 above.

Press “Settings” and the lights start ashing, at this point, you can check the

lifting height of the gun.

3. Pressing “Settings” one more time and you go back to battery indicator.

MAINTENANCE

Contents

Main EPX10 PIN BRAZING UNIT DECLARATION OF CONFORMITY Weisbeck, Andy Hydraulic Tools _______________________________________________ _______________________ All TABLE OF CONTENTS IMPORTANT LOCAL SAFETY REGULATIONS DANGER SAFETY SYMBOLS NOTICE IMPORTANT SAFETY PRECAUTIONS NOTICE CHARGING THE BATTERY PREOPERATION GENERAL PROTECTION CLEANING PREOPERATION PROCEDURES INITIAL SETUP AND BATTERY CHARGING IMPORTANT OPERATION LOADING PIN AND RING PIN BRAZE NOTICE OPERATION MAINTENANCE SPECIFICATIONS SPECIFICATIONS Special functions: Periodic maintenance of S15 automatic gun Lift level tool Advanced maintenance work Adjusting the liftlevel. Lift Level Tool TROUBLESHOOTING Error indications on the unit: PIN & RING HOLDERS CABLE LUGS (for Pin Brazing to rail) BRAZING PINS & CERAMIC RINGS STANDARD BRAZING PINS CERAMIC RINGS 35832 8 mm 35833 9.5 mm 35834 12 mm BONDING CABLE WITH LUGS "T" CONNECTORS (for Pin Brazing) TYPE C TYPE D Grinder Abrasives Fuses, Chargers, & Batteries GRINDER EPX10 User Manual 19 CABLES GUNS EPX10 PARTS ILLUSTRATION EPX10 PARTS LIST EPX10 ELECTRICAL DIAGRAM 12345678 G ECONECT_shema.sch F these units must be returned to the factory for battery replacement.