Stanley Black & Decker EPX10 these units must be returned to the factory for battery replacement.

1 28

EPX10 User Manual ◄ 23

REPLACING THE BATTERY

Econect battery kit P/N-73720 for serial number

1215091 and Higher.

Including:

Econect battery.

2 x 13mm spanner.

3mm hexagon key.

Side cutters.

Resistor 22Ohm/4W.

2 x Plastic washer.

3 x Cable ties.

The Battery kit (P/N-73720) and steps 1 thru 19 listed below applies only

to units with S/N 1215091 and Higher. For Units with serial number 1215090 & below,

1. Remove all screws on the sides of the unit

with a 3mm hexagon key.

2. Cut the cable ties for the positive and fan cable.

3. Pull out the connector for the fan.

Contents

Main EPX10 PIN BRAZING UNIT DECLARATION OF CONFORMITY Weisbeck, Andy Hydraulic Tools _______________________________________________ _______________________ All TABLE OF CONTENTS IMPORTANT LOCAL SAFETY REGULATIONS DANGER SAFETY SYMBOLS NOTICE IMPORTANT SAFETY PRECAUTIONS NOTICE CHARGING THE BATTERY PREOPERATION GENERAL PROTECTION CLEANING PREOPERATION PROCEDURES INITIAL SETUP AND BATTERY CHARGING IMPORTANT OPERATION LOADING PIN AND RING PIN BRAZE NOTICE OPERATION MAINTENANCE SPECIFICATIONS SPECIFICATIONS Special functions: Periodic maintenance of S15 automatic gun Lift level tool Advanced maintenance work Adjusting the liftlevel. Lift Level Tool TROUBLESHOOTING Error indications on the unit: PIN & RING HOLDERS CABLE LUGS (for Pin Brazing to rail) BRAZING PINS & CERAMIC RINGS STANDARD BRAZING PINS CERAMIC RINGS 35832 8 mm 35833 9.5 mm 35834 12 mm BONDING CABLE WITH LUGS "T" CONNECTORS (for Pin Brazing) TYPE C TYPE D Grinder Abrasives Fuses, Chargers, & Batteries GRINDER EPX10 User Manual 19 CABLES GUNS EPX10 PARTS ILLUSTRATION EPX10 PARTS LIST EPX10 ELECTRICAL DIAGRAM 12345678 G ECONECT_shema.sch F these units must be returned to the factory for battery replacement.