c
i
i’
,I,
:
:..,
:
-
-
I.
-
-
-__
..-
-.-
-..
-_.
-_
-^.
I.
_.
whether you want to fill your rectangular area with a solid black rule, a finely
dotted gray-scale pattern, or apredefined linear pattern. And with the Specify
Pattern command you can indicate which particular dotted or linear pattern
you want. You always send the Specify Pattern command before the Print
Pattern command, even if you want a solid black rule.
To indicate the particular pattern you want, send the following command.
The general meaning of the n value you enter actually depends on the
command you put after this:
<ES0 *c n G
If you want a solid black rule it doesn’t matter what you put in for n, as the
printer ignores it.
If you want a l-scale dotted pattern, for n you enter here a percentage number
from 1 to 100 indicating the density with which you want the box filled, from
light to solid. Your n percentage will correspond to one of the eight gray-
scale densities in the chart below.
l- 2% 3 - 10%
I-I trl 11 - 20 % 21 - 35 %
36 - 55 % 56 - 80 Yo
81 - 99 O/, 100 %
91