Star Micronics LC-90 NX-1010 user manual Starting up the User Setup Utility

Starting up the User Setup Utility 17

Starting up the User Setup Utility

❏To start up the User Setup Utility, move to the directory you specified under “Installing the User Setup Utility” on page 15. If you want to move to the directory we named “star” in our example in the previous section, you would input the following:

C:\>cd star ↵

❏Next, input the command to launch the User Setup Utility:

STARSET ↵

Exit Load Save General

Font Paper Adjust. Port Help

Emulation	(•) Standard	*	RAM
	( ) IBM		usage
NLQ			Sleep
	(•) Uni-direction	*
Direction	( ) Bi-direction
A.E.C.			Demo
	(•) Enabled	*
	( ) Disabled		Print

(•)	Input Buffer	*
( ) Download
(•)	15 min.	*
( )	30 min.
(•)	Self-print short	*
( )	Self-print long

Current Data: Current General Setting

TAB	= Next Box
SPACE	= Set Function

=Scroll up

=Scroll down

= Menu Select

When you start the User Setup Utility, it reads and displays the printer’s current settings.

❏Now you can use the pull-down menus described below to make the setup changes you want.

If the printer is not connected to your computer or if the power of the printer is switched off, the following message appears on the display when you start up the User Setup Utility.

Printer is not answering !

Please check the power and interface cables and try again

= Retry ESC = Cancel

Check the connection between the computer and the printer, and check the power. After correcting the problem, press Enter to continue.

The above message also appears when your computer and printer are connected through an optional Serial-to-Parallel Interface Converter. In such a case, simply press the computer’s ESC key to clear the message.