PRINTER CONTROL COMMANDS .
This appendix describes the printer’s control commands. The commands are
arranged by function. The name of each command is followed by a table like the
one below:
..,
i
Mode ASCII Decimal Hexadecimal
<ESC> “X” “ 1” 27 120 49 IB 78 31
Both <ESC> -X1’ Cl> 27 120 1 IB 78 01
Mode: Indicates the mode in which the command is recognized.
Std. Standard mode (DIP switch l-6 on)
IBM IBM mode (DIP switch 1-6 off)
Both Both standard and IBM modes
ASCII: Indicates the ASCII coding of the command. Control
characters are enclosed in pointed brackets: For example,
< 0 > means character code 0.
Decimal: Gives the command in decimal character codes.
Hexadecimal: Gives the command in hexadecimal character codes.
Parameters for which values must be supplied are indicated by italic letters
such as n.
Many commands have alternative forms. Some commands use < ESC>
(character code 27) in Standard mode and < FS > (character code 28) in IBM
mode. Other commands have parameters that can be specified as either character
codes or digit characters, like the parameter 1 in the sample command above.
FONT CONTROL COMMANDS
Select draft quality characters
~1
Changes from near letter quality to draft quality. Ignored if the NLQ
Type Style switch was pressed during power-up.
59