Star Micronics LC-IOII user manual Select double or quadruple size, Print, Characters

Select double or quadruple size

Mode	ASCII			Decimal		Hexadecimal
Both	<ESC>	“h”	n	127104	n	IIB 68	n	I

Selects the size of subsequent characters as shown below. Extra-high characters align along the cap-line of normal characters, with the base line temporarily moving down. Line spacing is temporarily doubled when n = 1, 5 or 6 and quadrupled when n = 2. To print correctly when n

=3,4,5 or 6, set the line spacing to 24/216 (l/9) of an inch with < ESC > “3” < 24 > , and print the same characters twice, upper half on one line, lower half on the next. For accurate alignment of the two halves, select

unidirectional printing with < ESC > “u” < 1 > .

n Effect

0 Normal size

1 Double-high, double-wide

2 Quadruple-high, quadruple-wide

3 Double-high, double-wide (Lower half only)

4 Double-high, double-wide (Upper half only)

5 Quadruple-high, quadruple-wide (Lower half only) 6 Quadruple-high, quadruple-wide (Upper half only)

Print	double-height		characters
IModel	ASCII		I		Decimal		I	Hexadecimal
Both	<ESC>	“WI’	“1”	27	119	49	1B	77	31
	<ESC>	-WT	Cl>	27	119	1	IB	77	01

I

Prints subsequent characters at double height without moving the base

line, and without changing the line spacing. Temporarily cancels super/subscript and condensed printing modes.

Return to normal height

Model ASCII

<ESC> “W”

Both -

<ESC> “WI’

		Decimal			Hexadecimal		I
“0”	27	119	48	1B	77	30
co>	27	119	0	1B	77	00

Terminates double-height printing and prints subsequent characters at normal height. Resumes super/subscript and condensed printing if these modes were in effect before double height was selected.

69