– 21 –
ENGLISH
6. Adjusting the Near-end Sensor
Use the following procedure to adjust the near-end sensor so it is compatible with
the size of roll paper you are using.
1Open the printer cover.
2Determine the diameter of the roll paper you are using and find the required
setting in the table below.
3Insert the tip of a ballpoint pen or similar pointer object into the hole of the
adjuster. While pressing the adjuster, slide it up or down to the setting that
matches the roll paper you are using.
Make sure the tab indicated by the arrow in the illustration is inside one of the
grooves.
Important!
The wall mount model can only be used at level 3, and therefore must not
be modified. Make the necessary adjustments to the standard model.
Level 3
Level 2
Level 1