– 113 –
APPENDIX
(3) DP8340 mode
Switch
Function ON OFF
1-1 Command emulation Always ON
1-2 Command emulation Always OFF
1-3 Control cord CR Invalid Same as LF
1-4 Character table (See below)
1-5 Character table (See below)
1-6 International character set (See below)
1-7 International character set (See below)
1-8 International character set (See below)
Character Table
Switch
USA & Europe IBM#1 IBM#2 JAPAN
1-4 ON OFF ON OFF
1-5 ON ON OFF OFF
International
Character Set
Switch
USA France Germany England Denmark Sweden 1 Itary Spain 1
1-6 ON OFF ON OFF ON OFF ON OFF
1-7 ON ON OFF OFF ON ON OFF OFF
1-8 ON ON ON ON OFF OFF OFF OFF
(4) ESC/POS mode
Switch
Function ON OFF
1-1 Command emulation Always OFF
1-2 Command emulation Always OFF
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment Invalid Valid
1-5 Pin #31 (INIT) reset signal Valid Invalid
1-6 Handshaking conditions Offline or receive Receive buffer full
(conditions for BUSY) buffer full
1-7 Automatic status back function Invalid Valid
1-8 Should not be changed (Should be set to on)
DIP-SW 2
Switch
Function ON OFF
2-1~2-4 Always ON Should be set to on
The factory settings of DIP switch are all on.
■Printer Driver
The printer driver can be downloaded from the following website.
Printer Driver URL : http://www.star-m.jp/eng/dl/dl02.htm