Star Micronics TUP942 Power LED, Normal State, Presenter Paper Jam Errors, Non-recoverable Errors

1When Power is ON

18

SW Input	Operation
SW1	Self-test Print
SW2	Hex Dump Mode

2When in Sensor Adjustment Mode and Power is ON (Sensor Adjustment Mode is selected using by setting the DIPSW1-4 on the main board to OFF.)

SW Input	Operation
No SW Input	Sensor Adjustment Mode for PE/Black Mark
3 When Online
SW Input		Operation
SW1		Paper Feed (*1)
SW1 + SW2 (Hold for 2 sec.)		Printer Software Reset
*1) Details for Paper Feed Specifications
Presenter Contact Status	Black Mark Function		Paper Feed Specifications
Non-contact	Disabled		Paper feed continues while SW1 is input
	Enabled		Performs TOF operation
Contact	Disabled		Paper Feed + Full Cut + Presenter Paper Discharge
			Ignores SW input under the following conditions
			• When LF motor is operation
			• When paper is being supplied to the presenter
	Enabled		TOF + Full Cut + Presenter Paper Discharge
			Ignores SW input under the following conditions
			• When LF motor is operation
			• When paper is being supplied to the presenter
4 When errors occur
SW Input	Operation
SW1	Paper Discharge (*2)
	Function executed only under the following conditions
	• Cover is closed • No Paper
SW2	Error cancel operation (according to MSW1-E settings)

*2) Paper Discharge

This function cancels the paper wait state of the platen that exists when there is no paper detected when printing by feeding paper. Paper can be easily removed without opening the cover, by using this function. However, caution must be exercise in using this function when there is no paper being waited for at the platen because over use can damage the print head.

	Status					LED Specifications
				Power LED			Error LED
Normal State					ON			OFF
Auto-recovery Error		Printing stops because of	Blink 500msec					OFF
		detection of the high
		temperature of the head
Recoverable Errors		PE Error			ON		Blink 500msec
		NE Error			ON		Blink 2000msec
		Cover Open Error			ON			ON
		Black Mark Error			ON		Blink	500msec
Non-recoverable Errors		Auto-cutter Errors			OFF		Blink	125msec
		Presenter Paper Jam Errors			OFF		Blink	250msec
		FLASH Access Errors			OFF		Blink	500msec
		EEPROM Access Errors			OFF		Blink	750msec
		SRAM Access Errors			OFF		Blink 1000msec
		Thermistor Errors			OFF		Blink 1500msec
		Power Voltage Errors			OFF		Blink 2000msec