Star Micronics TUP992, TUP942 manual Dip Switch Setting, When mounted with a parallel interface

21

Dip Switch Setting:

1) When mounted with a parallel interface					<At Ex-factory: All are turned ON.>
DIPSW1	Function		ON				OFF
DIPSW1-1	Emulation		See table below *2
DIPSW1-2	Emulation		See table below *2
DIPSW1-3	(Reserved: Fixed at ON)	-				-
DIPSW1-4	Sensor Adjustment Mode		Enabled				Disabled
DIPSW1-5	Reset by INIT Signal		Enabled				Disabled
DIPSW1-6	BUSY Condition		Reception Buffer Full/OFF-LINE				Reception Buffer Full
DIPSW1-7	(Reserved: Fixed at ON)	-				-
DIPSW1-8	NE Sensor Contact State (*1)		Non-contact				Contact
2) When mounted with a RS-232C interface				<At Ex-factory: All are turned ON.>
DIPSW1	Function		ON				OFF
DIPSW1-1	Emulation		See table below *2
DIPSW1-2	Emulation		See table below *2
DIPSW1-3	(Reserved: Fixed at ON)		-				-
DIPSW1-4	Sensor Adjustment Mode		Enabled				Disabled
DIPSW1-5	(Reserved: Fixed at ON)		-				-
DIPSW1-6	BUSY Condition		Reception Buffer Full/OFF-LINE				Reception Buffer Full
DIPSW1-7	(Reserved: Fixed at ON)		-				-
DIPSW1-8	NE Sensor Contact State (*1)		Non-contact				Contact

*1: Be aware that operations are not guaranteed if the state set using this bit and the actual NE (Near- End) sensor contact state are different.

*2: Emulation

DIPSW1-1	DIPSW1-2	Emulation
ON	ON	STAR Line Mode
OFF	ON	STAR Page Mode (supported by ROM version 2.0 later)
ON	OFF	(Reserved)
OFF	OFF	ESC/POS Mode (supported by ROM version 3.0 later)

Star Micronics America, Inc., 1150 King Georges Post Rd, Edison, NJ 088371 Date: 12/3/2007