Spinner® Velo XT
O W N E R ' S M A N U A L
CHAIN TENSION ADJUSTMENT
During normal operation of your Spinner® Velo XT it may become necessary to loosen or tighten your chain for optimum performance. If you have any ques- tions regarding your chain tension, please contact Star Trac customer service at (800)
1To access the axle nut on the right side of the Spinner Velo XT you will need to first remove the flywheel adjustment cover. Using a flat head screw driver gently pop out the flywheel adjustment cover from the chain guard.
2Using the 16mm or 5/8” socket and socket wrench loosen the axle nuts on the sides of the flywheel.
3To tighten the chain, turn the adjustment screw in a clock wise rotation equally on both sides using a 4 mm allen wrench.
4 To tighten the chain, turn the adjustment screw in a clock wise rotation equally on both sides using the 10mm open end wrench.
5While adjusting the chain tension, work on both sides of the flywheel. Adjust the angle of the flywheel so it is straight front to rear and evenly spaced within the frame side to side
as shown in the photo.
6Adjust the angle of the flywheel by adjusting the adjustment
screws on both sides of the flywheel test by slowly rotating the pedals.
a.If the chain is stretched beyond adjustment the replacement of the chain is recommended. Please
contact Star Trac® customer service at (800)
7Tighten the adjustment lock nuts and the axle nuts on both sides alternating from side to side. Replace the flywheel adjustment cover before operation.
WARNING REMOVAL OF THE CHAIN GUARD IS STRONGLY DISCOUR- AGED AND SHOULD ONLY BE PERFORMED BY AN AUTHORIZED STAR TRAC® TECHNICIAN. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SEVERE INJURY.
S AV E T H E S E I N S T R U C T I O N S
12
