Drawings and Diagrams | Sterling 882.00274.00 specification

16.Functional identification

17.Additive Feeder is equipped with a CE mark

18.Additive Feeder is supplied with an operating manual in the language of the destination country.

19.Cable support may be required for power cord, depending on final installation.

20.No one is required to be in the interior of the electrical enclosure during the normal operation of the unit. Only skilled electricians should be inside the enclosure for maintenance.

21.Doors can be opened with a screwdriver, but no keys are required.

22.Two-hand control is not required or provided.

23.All additive feeders should be moved around and set in a place with a lift truck or equivalent.

24.There are no frequent repetitive cycles that require manual controlrepetitive functions are automatic while the additive feeder is operating.

25.An inspection report detailing the functional test is included with the additive feeder.

26.The machine is not equipped with cableless controls.

27.Color-coded (harmonized) power cord is sufficient for proper installation.

7-4 Drawings and Diagrams

Figure 6: Additive Feeder Specifications and Overall Dimensions

Additive Feeders

Chapter 7: Appendix

41 of 50

Image 42

Sterling 882.00274.00 specifications Drawings and Diagrams, Additive Feeder Specifications and Overall Dimensions

Contents

SF Series Additive Feeders Parts and Service Department Shipping Information Table of Contents Troubleshooting Safety How to Use This ManualSafety Symbols Used in this Manual Wear Safety Glasses and Work Gloves Responsibility General Responsibility Operator Responsibility Remember Maintenance Responsibility Reporting a Safety Defect Functional Description Standard FeaturesMechanical Features Models Covered in This Manual Electrical Features Controller FeaturesOptions Accessories Safety Devices and Interlocks Safety Circuit StandardsFail Safe Operation Safety Device Lock-Outs Uncrating the Equipment InstallationSupply System Installation Rigging and Placing the Additive Feeder Main Power Connection Electrical ConnectionsControl Relay Connection Setup Procedures Determining the Desired Feed Rate 110 100 Calibration Procedure ProcedureEquipment Needed Examples Observed Feed Rates Starting Up the Additive Feeder Initial Start-upPre-Startup Checks Shutting Down the Additive Feeder Operation SwitchesIndicator Lights Start-up Timer Module Used as a Cycle Override Safety TimerCounter Module Elapsed Time Module Regrind Feeder with Proximity Switch Dual Setpoint Control Operation 2 Component ApplicationsSet Point #2 Motor Control Bottom Low Level Extruder Tracking Installation and Setup Extruder Tracking Control Extruder Tracking Equation Equation Desired Display SettingField Control Programming Motor RPM = 25.2 X Auger RPM Programming Mode Viewing or Changing the ConstantProgramming for Follower Operation Exiting Programming Mode and Returning to Run Mode Viewing or Changing the Program Minimum SettingViewing or Changing the Program Maximum Setting Program Minimum Setting Additive Feeder Control Factory Defaults Shutting Down the Additive Feeder Maintenance Preventative Maintenance SchedulePhotocopy this page for your maintenance records Preventative Maintenance Material Cleanout/Changeover Removing Auger Assembly Corrective MaintenanceAuger Assembly Changeover Installing Auger Assembly Motor Brush Replacement Replacement Motor Brush Part Numbers Troubleshooting Problem Possible cause Corrective actionIntroduction Additive Feeders Troubleshooting Warranty Appendix Optional Components Technical Specifications Annex B Information Drawings and Diagrams Additive Feeder Specifications and Overall Dimensions Typical Additive Feeder Controllers SET Point Spare Parts List Exploded Assembly Drawing Parts List A0541292 Auger Assembly, 1/2 One Component Control Enclosure Parts Identification Two Component Control Enclosure Parts Identification Additive Feeder Safety Tags Safety Tag InformationWarranty Returns Returned Material Policy Additive Feeder Identification Serial Number Tag Technical Assistance Worksheet for Charting Feed Rates Photocopy this page for your records