&
STT 1600
If the unit operates with motor flaps (optional):
Granules X
target: _ % = _ °C (°F)
(X = number of the drying hopper)
Enter the material temperature at which the flap (optional) on the drying hopper X should close. Confirm with the ENTER key.
&
This value is entered in percent of the temperature on the hopper inlet.
The material temperature calculated by the control system for closing the flap on the drying hopper X is displayed in °C (°F).
Granules X
act.: _ °C (°F)
(X = number of the drying hopper)
The current material temperature in the drying hopper X is displayed in °C (°F) (optional, if there is a flap).
Press the
