Sterling Plumbing 5400 Series manual Install the Hanger Bracket, Installer le support d’ancrage

7.Install the Hanger Bracket

Bolt

Boulon

Perno

Bushing

Bague

Buje

Hanger Bracket Support d'ancrage Soporte de suspensión

Blind Nut Écrou borgne Tuerca ciega

Roller

Rouleau

Rueda

Roller Steel Side Côté rouleau en acier Lado de acero de la rueda

#8-32 x 3/8" Screw Vis #8-32 x 3/8" Tornillo del #8-32 x 3/8"

Hanger Bracket Support d'ancrage Soporte de suspensión

Insert a bushing into one of the holes at the top of one of the glass panels.

Install a hanger bracket over the glass panel with the mounting hole aligned with the bushing.

Insert a blind nut through the hanger bracket hole and bushing. Secure with a bolt.

Repeat the procedure with each hanger bracket on the door panels.

NOTE: The steel side of the roller must be installed against the hanger bracket.

NOTE: There is a label on the each glass panel identifying the ″Non-coated side″ of the panel.

Use #8-32 x 3/8″ panhead screws to attach two rollers on each glass panel. The rollers on one glass panel should be installed on the ″Non-coated side″ of the door. This will be the outside panel. The rollers on the other door panel should be installed opposite the ″Non-coated side″ of the door panel. This is the inside panel.

Installer le support d’ancrage

Insérer une bague dans un des orifices au dessus d’un des panneaux en verre.

Installer un support d’accrochage sur le panneau en verre avec l’orifice de montage aligné avec la bague.

Insérer un écrou borgne dans l’orifice de support d’accrochage et dans la bague. Sécuriser avec un boulon.

Sterling 15 1063216-2-E