Seal the Bottom Track | Install the Bottom Track |
Apply silicone sealant here.
Underside of
Strike Side
Plastic Plug
Bottom Track
Pivot Bushing
Bottom Track
Pivot Side
Masking Tape
6. Caulk and Install the Bottom Track
Remove the bottom track.
Apply silicone sealant to the underside of the bottom track, as shown.
Make sure the ledge is clean and install the bottom track at the location marked on the shower ledge.
Use masking tape to hold the bottom track in place.
IMPORTANT! Illustration shows a left side pivot. Reverse the pivot bushing and plastic plug for a right side pivot.
Insert the plastic plug into the hole on the strike side of the bottom track.
Insert the pivot bushing into the hole on the pivot side of the bottom track.
Sterling | 9 |
