Sterling Plumbing SP5400 Series Mark the Wall Jambs, Marquer les montants du mur, Mark holes

		Square end of wall
		jamb
Mark holes.		Extrémité carrée
		du montant du mur
Marquer les orifices.		Extremo cuadrado
Marque los orificios.
		de la jamba mural
	Drill holes.
	Percer des trous.
	Taladre los orificios.
Level	Insert anchors.
	Insérer les dispositifs d'ancrage
Niveau à bulle
	Inserte los anclajes.
Nivel
		Contoured (rounded)
		end of wall jamb
Wall Jamb		Extrémité contournée
Montant du mur		(arrondie) du montant
Jamba mural		du mur

Extremo contorneado (redondeado) de la jamba mural

Threshold

Seuil

Umbral

Mark the Wall Jambs

Position a wall jamb against the wall directly over the bottom track with the shorter leg facing out. The wall jamb should sit flat against the wall.

Slide the wall jamb down over the bottom track until the wall jamb and bottom track are fully engaged.

IMPORTANT! The wall jamb must sit flat on the bottom ledge. If your ledge has a curve in the corners at the side wall, it may be necessary to shape the bottom end of the wall jamb with a file.

Use a level to plumb the wall jamb vertically.

Using the pre-drilled screw holes as a guide, mark the hole locations on the wall. Repeat the procedures with the second wall jamb.

NOTE: When installing on ceramic tile, use a center punch to nick the surface of the glaze. Tap the center punch lightly with a hammer to avoid cracking the tile.

Lightly center punch the hole locations.

Drill a 5/16″ hole at each mark. Use a tile or masonry bit for ceramic tile.

Thoroughly clean the shower floor ledge and wall. Insert plastic anchors in each hole.

Marquer les montants du mur

Placer un montant du mur contre le mur directement sur le rail inférieur avec le pied le plus court vers l’extérieur. Le montant du mur devrait bien reposer à plat contre le mur.

1067873-2-A 10 Sterling