English / USA

Adjusting the Throttle Cable

8

8 7

7 4

3 5

6

 

1

KN

1

002BA136

 

 

 

Loop Handle without Barrier Bar

:Place the clamp (3) in the loop handle (4) and position them both against the drive tube (5).

:Fit the clamp (6) and line up the holes.

:Fit washers (7) on screws (8) and insert screws in holes. Screw on the square nuts (1) as far as stop.

:Go to “Securing the Loop Handle”.

A

9

4

10

002BA147 KN

Securing the Loop Handle

:Secure the loop handle (4) approx. 8 in (20 cm) (A) forward of the control handle (9).

:Line up the loop handle.

:Tighten down the screws firmly – lock the nuts if necessaey.

:The sleeve (10) is country-specific and must be located between the loop handle and control handle.

A properly adjusted throttle cable is the precondition for correct operation in the full throttle, starting throttle and idle positions.

Adjust the throttle cable only after the unit is fully assembled – the control handle must be in the normal operating position.

002BA163 KN

:Use a suitable tool to push the slide to the bottom of the slot (see illustration).

24

FS 120, FS 120 R, FS 200, FS 200 R, FS 250, FS 250 R