SECTION 3

INITIAL SET-UP AND OPERATION

3.1 SAFETY PRECAUTIONS

SAFE OPERATION IS NO ACCIDENT; observe these rules:

A.Know the freezer. Read and understand the operat- ing instructions.

B.Notice all warning labels on the freezer.

C.Wear proper clothing. Avoid loose fitting garments, and remove watches, rings or jewelry which could cause a serious accident.

D.Maintain a clean work area. Avoid accidents by cleaning the area and keeping it clean.

E.Stay alert at all times. Know which switch, push button or control you are about to use and what effect it is going to have.

F.Disconnect electrical power for maintenance. Never attempt to repair or perform maintenance on the freezer until the main electrical power has been disconnected.

G.Do not operate under unsafe operating condi- tions. Never operate this freezer if unusual or exces- sive noise or vibration occurs.

3.2OPERATING CONTROLS AND INDICATORS Before operating the freezer, it is required that the op- erator know the function of each operating control. Refer to Fig.11 for the location of the operating controls on the freezer.

WARNING

Hazardous voltage

TheCLEAN-OFF-ONswitchmustbeplacedintheOFF position when disassembling for cleaning or servicing. The freezer must be disconnected from electrical supply before removing any access panel. Failure to disconnect power before servicing could result in death or serious injury.

A.Spigot Switch

When the spigot handle is opened the SPIGOT switch will start the auger drive and refrigeration systems. When the spigot handle is closed, the drive motor and compressor will remain on until the product in the barrel reaches the proper temperature.

B.Clean-Off-Serve Switch

The CLEAN-OFF-SERVE switch is a three position toggle switch used to control the operation of the refrigeration system and auger. When the switch is placed in the CLEAN position, the refrigeration sys- tem will be off and auger will rotate for cleaning.

Figure 11. Operating Controls

9