G.Assemble O-rings onto the spigot dry, without lubrication. Then apply a thin film of sanitary lubricant to the outside of the O-rings and spigot bodies.

H.Install the spigot through the bottom of the front door ( see Figure 18).

Figure 18. Front Door Assembly

I.Assemble the air bleed valve O-ring onto the air bleed valves. Position the O-ring in groove close to the wide part. Apply a thin film of sanitary lubricant to the O-rings.

J.Insert the air bleed valve from the back of the front door. Install compression springs onto air bleed valves, then screw knobs on finger tight.

K.Apply a thin film of sanitary lubricant to the door seal O-rings, and fit into the grooves on the rear of the front door.

L.Place the front door assembly on the mounting studs and push front door against the freezer carefully.

M.Secure front door assembly by placing the knobs on the studs and tighten until finger tight only. Do not overtighten. ProperO-ring seal can be observed through the transparent front door.

N.Move the spigot handles to the closed position.

15