SERVICING INSTRUCTIONS
REPLACING PARTS
3.3The pilot unit can now be removed by undoing the two screws. See diagram 6.
6
AR1445
3.7Reassemble in reverse order, do not overtighten.
NOTE: SPECIAL CARE SHOULD BE TAKEN WHEN REPLACING THE THERMOCOUPLE TO THE BACK OF THE GAS VALVE TO ENSURE THAT THE SENOR WIRES FOR THE GAZCO FLUE SURE SYSTEM ARE NOT DISCONNECTED.
4.IGNITION LEAD
4.1Gain access to the pilot assembly, see section 3 and disconnect the ignition lead from the electrode.
4.2Remove the front cover from the control valve, see diagram 7 and 8, disconnect the other end of the ignition lead from the valve body, note the existing route of the ignition lead.
7
AR0915
8
AR0916
4.3Replace with a new ignition lead following the same route as the old one. Replace the valve cover and the pilot assembly.
4.4Check operation of the new ignition lead.
5.PIEZO
5.1The piezo assembly used on this appliance is not serviceable and is unlikely to fail.
17
