MAINTENANCE and SERVICING
• Tighten the screws evenly until the clips hold the glass
Do not over tighten the clips as this could break the glass.
6.3Fit only Stovax ceramic glass, which is suitable to use in high temperature applications.
6.4Using the appliance with damaged door glass could allow dangerous fumes to enter the room, or the appliance to
7.Fitting a new door seal
7.1To maintain the safe use of your appliance you may need to replace a damaged or worn door sealing rope.
7.2To complete this operation:
•Open the door
•Lift it free of the hinge blocks
•Lie the door face down on a soft flat surface, to protect the paintwork and glass
Single Door
Seal 14mm
Joint |
|
|
|
|
|
| PR7084 |
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Double Door |
|
|
|
| Seal 14mm | ||
|
|
|
|
|
| ||
|
|
|
|
|
| ||
|
|
|
|
|
|
| Seal 10mm x 2mm |
|
|
|
|
|
|
| |
PR7085
•Remove the old rope
•Scrape old glue from the locating groove
•Clean the locating groove with a clean dry cloth removing all dust and debris
•Apply Stovax Thermic Seal glue (Stovax Part No. 5037) into the rope locating groove
•Press the new Stovax rope into the locating groove, placing the joint in the middle of the lower edge of the door
•Refit the door
•Close to apply pressure on the new rope
•Leave the appliance closed for at least 12 hours before lighting the stove
•Use at a low output for approximately one day
7.3Using the stove with a damaged door seal could allow dangerous fumes to enter the room, or the appliance to
8.ADJUSTING DOOR HINGES
8.1To maintain the safe use of your appliance, you may need to adjust the door hinges to ensure the door closes safely and correctly.
8.2To complete this operation:
• Open the door to give access to the fixed part of the door hinge as shown
Fixing Nut Lock Nut
PR7087 | PR7086 |
•Use a 19mm A/F spanner to loosen the fixing nuts
•Reposition the hinge blocks to achieve a correct fit
This may require several adjustments to find the correct position.
27
