USER INSTRUCTIONS
IF THE FIRE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE FIRE. THE CONTROL VALVE HAS AN INTERLOCK DEVICE AND THEREFORE CANNOT BE LIT UNTIL THE 3 MINUTES HAVE ELAPSED.
2.2 To adjust the flame height
Once the pilot has been lit the main burner can be lit and adjusted.
2.2.1Press the (
) UP button (10). The flame symbol (1) will show one extra flame. This is to indicate the burner is on its lowest position.
2.2.2Press the same button again and the burner will be in the medium position.
2.2.3Press the button again and the burner will be in the maximum position.
2.2.4Press the ( 
) DOWN button (13) one step at a time and this will reduce the burner from maximum to medium then to minimum.
2.2.5If the ( 
) DOWN button is pressed once more, only the pilot will remain alight.
2.3 To turn the F40 Avanti off
The F40 Avanti can be turned off with the flames in any position, ie minimum, medium or maximum. It can also be turned off from the pilot only position.
2.3.1Press the ON / OFF button (11) the word OFF appears in the display.
2.3.2Press the SET button (12) and the fire will turn off. NOTE: The pilot can be left on if so desired
2.4 To change from Manual to Automatic mode
2.4.1The hand set display will show the word MANUAL (8)
2.4.2Press the SET button (12) once and the word AUTO will flash.
2.4.3Press the SET button (12) again and the word AUTO will stop flashing.
2.4.4The room temperature display is now flashing and ready to be set.
2.5 To set the room temperature
2.5.1Following on from section 2.4, once the room temperature is flashing on the display, it can be set.
2.5.2Press either the (
) button (10) or the ( 
) button (13) to either increase or decrease the temperature.
2.5.3Press the SET button (12) once you have set the temperature as desired.
If the SET button (12) is not pushed the temperature display will stop flashing and remain unchanged.
2.6To change from Automatic to Manual mode.
2.6.1The hand set display will show AUTO (8).
2.6.2Press the SET button (12) once and the word MANUAL will flash.
2.6.3Press the SET button (12) again and the word MANUAL will stop flashing.
You are now in Manual mode.
2.7 Low battery display (Hand Set)
The low battery symbol (6) will appear on the hand set when the batteries require replacement.
2.8 Lighting the F40 Avanti (Touch Pad)
2.8.1The touch pad is located behind the main door. To open the door, press the lower right hand corner of the door until a click is heard, open the door and the touch pad can be seen. See diagram 3.
3
AR1466
2.8.2Press the ON / OFF button (A) once and the red LED will flash. The pilot will now light. This should take about 10 seconds. If the pilot does not light press the ON / OFF button again to reset the control unit and repeat step 1 above. Before the burner can be lit wait for the audible click. See diagram 4.
2.9 To adjust the flame height (Touch Pad)
2.9.1Once the pilot has lit press the Up (
) button (B) and the burner will light. See diagram 4.
2.9.2Press either of the (
) buttons (B / C) to adjust the height of the flames. See diagram 4.
5
