USER INSTRUCTIONS
4.FUEL BED ARRANGEMENT
4.1Place the flame baffle onto the burner and push against the rear tray lip. See diagram 6
6
AR0359
4.2Locate the rear panel against the spacer brackets and slide down so that it locates on the ledge of the flame baffle. See diagram 7
7
AR0360
4.3Locate the front coal between the heat shield and the flame baffle so its ends sit flat on the burner skin. See diagram 8
8
AR0361
4.4Place five of the loose round coals on the front coal so they lean against the flame baffle, in between the fingers. Place the two rectangular coals against the reflector panels, one either side, behind the front row of loose coals. See diagram 9
9
AR0362
4.5Place four of the loose round coals behind the first row so that they sit on the fingers, the two outer ones should touch the rectangular coals. See diagram 10
10
AR0363
4.6Place the three remaining coals behind the centre row so that they touch the back panel. See diagram 11
11
AR0364
5.GAZCO FLUE SURE SYSTEM
5.1The stove is fitted with the Gazco Flue Sure System, which will act to cut off the gas supply to the burners in the event of incorrect operation of the flue. If the system acts to cut off the gas supply, this indicates that there is insufficient flue pull. If this occurs a minimum of 10 minutes should be allowed before trying to relight. Continued operation of this safety device means there may be a serious problem with the flue system. A qualified gas engineer should inspect this.
Do not use the stove until an engineer says it is safe to do so.
7
