![](/images/new-backgrounds/1136696/13669645x1.webp)
MS15H/MS15E MIXER — START-UP PROCEDURES
4.Turn the engine switch (Figure 12) to the ON position.
Figure 12. Engine ON/OFF Switch (ON)
Be sure to stand clear of the dump handle when the mixer
NOTEis operational. Any binding of material between the mixer blades and the drum will cause the drum handle to move to the discharge position, thus causing bodily harm.
Stopping the Mixer (Electric Motor)
1.Place the engine ON/OFF switch (Figure 14) in the OFF position.
7.Pull the starter grip (Figure 13) lightly until you feel resistance, then pull briskly. Return the starter grip gently.
Figure 13. Starter Grip
Starting (electric only)
1.Using an adequate size extension cord (see Table 4), connect one end of the extension cord to the plug on the electric motor, connect the other end to the power source. Make sure the motor is configured for the proper operating voltage.
2.Set the electric motor's ON/OFF switch (Figure 5) to the ON position.
Mixing Dumping
1.The paddle shaft inside the drum should be rotating at this time.
2.Lift the mixing bag compound onto the steel grate over the bag cutter and let the contents fall into the drum.
3.Add water, and mix compound to desired consistency.
Figure 14. Engine ON/OFF Switch (OFF)
2.Place the fuel
3.Disconnect the spark plug wire.
4.Clean drum of all debris and foreign matter.
5.Store mixer in a clean dry location.
| DANGER | DO NOT Disconnect |
| the Start/Stop Switch | |
|
|
NEVER disable or disconnect the start/stop switch. It is provided for operator safety. Serious Injury may result if it is disabled, disconnected or improperly maintained.
Stopping the Mixer (Electric Motor)
1.Place the electric motor's ON/OFF switch in the OFF position.
2.Disconnect the electric motor's extension cord from its power source.
3.Clean drum of all debris and foreign matter.
4.Store mixer in a clean dry location.
MQ STOW MS15H/MS15E MIXER — PARTS & OPERATION MANUAL — REV. FINAL (08/10/06) — PAGE 23