S U B - Z E RO MODEL 315W I N S TA L L AT I O N

OVERLAY PANEL I N S TA L L AT I O N

A decorative panel is attached to the Model 315W door using #8 x 5/8" (16) square drive screws passing through the door frame from the rear, behind the gasket into the panel. The door panel is marked for screw locations by the use of 'tenon centers', which are temporar- ily inserted into the 1/4" (6) diameter holes in the front of the glass door frame. Refer to the illustration below.

With the unit secured in position and the door closed, the panel is held in the desired position on the door and rapped by hand from the front, putting center marks on the rear surface of the panel. If the door panel is made of such

amaterial that pre-drilling is needed, all of the mounting holes should be marked. If not, only enough holes to hold the panel in place temporarily are necessary.

The door panel is then removed from the door frame, tenon centers removed, the door opened and the screws driven into the panel through the black tape on the door frame, using the center marks to locate the screws.

The screw holes inside the door, are hidden under a cover flap on the door gasket. It is necessary to lift the flap to insert the screws. Use as many screws as necessary to hold door panel in place properly.

IMPORTANT NOTE: After the first three or four mounting screws are in place, but not completely tightened, close the door and check your panel fit. This is the time to make small adjustments. Once you are satisfied with the appearance, open the door and apply the remainder of the screws. Check all screws for tightness.

The metal frame on the glass door has numerous mounting holes on each side of the door. This is to accommodate the Sub-Zero accessory handles and provide for easy attach- ment of the handle through the door frame.

The illustration below shows how the holes pass through the door frame. The hole center is on the small locator groove in the front of the frame. A 1/4" (6) diameter hole is made in the front wall of the extrusion and a 13/32" (11) diameter hole through the rest of the frame.

Exercise caution when drilling holes for mounting the panel to the door frame.

Overlay

Panel

Door

Frame

Tenon Center

Overlay door panel

Gasket

13/32" (11)

 

 

Diameter

 

Glass

 

1/4" (6)

 

Diameter

Door frame cross-section

11

Page 11
Image 11
Sub-Zero 315W manual Overlay door panel