Sub-Zero 315W manual Cleaning, T E R I O R C L E a N I N G, A S S D O O R C L E a N I N G

S I G N AT U R E P O L I S H

Signature Polish is available from Signature Limited Laboratory,

P. O. Box 13436, Dayton, Ohio 45413-0436, or call 877-376-5474 (toll free).

S U B - Z E RO MODEL 315W O P E R AT I O N

CLEANING

E X T E R I O R C L E A N I N G

To clean the classic stainless steel exterior of the Model 315W/S, use a soft, nonabrasive stainless steel cleaner like Signature Polish (see side note) and apply with a soft 100% lint-free cloth.

If anything spills onto the door gasket, wash with soap and warm water to remove. Rinse and dry thoroughly.

G L A S S D O O R C L E A N I N G

The glass door panel can be cleaned using any standard glass cleaner available on the market today.

I N T E R I O R C L E A N I N G

To clean interior surfaces and removable parts, wash with a mild solution of soap and luke- warm water with a little baking soda. Do not use vinegar. Rinse and dry thoroughly. Avoid getting water on lights, control panel and the solid cherry wood facing on the shelves.

Do not use abrasive cleaners or cloths on any of the interior or exterior surfaces, including the glass door panel.

C L E A N I N G T H E C O N D E N S E R

Before cleaning the condenser and other routine maintenance, shut off power at the circuit breaker suppling power to the electrical outlet.

The air-cooled condenser should be vacuumed two to three times per year to remove any lint that may have been drawn into the condenser. To access the condenser, use a phillips head screw driver to remove the kickplate as shown in the illustration below. Then using a soft bristle brush, vacuum to remove dust and lint from the condenser. Refer to the illustration below.

IMPORTANT NOTE: To avoid bending the condenser fins, be sure to vacuum in the direc- tion of the fins (up and down).

Failure to clean the condenser could result in temperature loss or mechanical failure or damage.

CONDENSER

FINS

Kickplate removal Cleaning the condenser

16