PA N E L
D E S I G N
Additional panel design information can be found in the
S U B - Z E RO MODEL 315W I N S TA L L AT I O N
OVERLAY PANEL I N S TA L L AT I O N
IMPORTANT NOTE: Install screws in all the mounting holes in the door frame. The nature of the door panel with a narrow outer rim and no connecting center member requires the support provided by the glass door.
After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door.
The cover patches or plugs are part of the insulation system on the door of the wine cooler. Be sure to cover all the holes in the door that were used.
The wine cooler door is made with
a sealed double wall tempered glass core. The drill must not contact this core when drilling. Be sure the hole is centered on the small groove in the front of the door frame and the drill passes squarely through the frame. If you are inexperi- enced with drilling, fasten the handle from the rear of the door panel only.
12
