INSTALLATION
INSTRUCTIONS
Il
I
FOR l,"THRU |
'5"GRILLES |
II" GRILLE ONLY
532 & 590
1," THRU 1S" GR1LlE
ALL OTHER MODELS
ADD SCREW GROMMET
TO PROPER HOl£
10· GRILLES
".
""IN
FIlAME
~--~--~
SCREWOROIoIMET | ~ | |
p .... • ....14".0 | _ |
| USE EXISTING QRIU,£ |
~~~l~~~ | SCREW fOR(IlIID£ |
! UPPER QRILU S~~:
TEMPLATE
ElllARGE TO 3,0,," OI.UlE'TER | 1: |
| lOWER GRillE SCREW |
|
PILOT HOLES
DRILL WITH 11.· DRILL 81T
Figure 20
Figure 21
C)Slide panel into position in grille frame as shown in Figure 22.
NOTE: When using '/4" or less, a filler is necessary.
A)Remove louvered grille. Refer to step 7.
B)Open the door(s) and attach template provided with panel grille installation kit. The template center hold must be aligned with the grille screw hole and you must fasten from the top down with the screw you removed in step A. See Figure 20.
C)With template in place, drill '/8" pilot holes in the end holes of the template. See Figure 20. Enlarge pilot holes by drilling 3f,e" finished holes. After drilling holes, remove template and discard. Keep screw for later installation.
D)Install screw grommets in properly labeled holes in Figure 20 in the shroud assembly.
E)Attach the outer grille frame to the shroud assembly by inserting the two upper grille screws into their proper holes and with door(s) open install the lower three grille screws as shown in Figure 20 and Figure 10.
F)Refer to Model 590 grille installation, steps B through E, on this page for the remainder of the assembly.
MODEL 590
(STANDARD FEATURE)
EA GRILLE PANEL SIZE
Grille Size Panel Size
10 x 48 | 83 f,6 | x 463 f,6 |
11 x48 | 93 f,6 | X 463f,e |
12 x48 | 103 f,6 | X 463 f,6 |
13x48 | 113f,6x463 /,6 | |
14 x48 | 123 f,6 | X 463 f,6 |
15 x 48 | 133 f,6 | x 463 f,6 |
A)Remove the inner grille panel assembly (refer to step 7).
B)Remove the top two corner screws and pull away the top frame. See Figure 21.
Figure 22
D)Reattach the top frame by reinstalling the two top corner screws.
E)Install inner grille panel assembly back onto product (refer to step 7).
7