Sub-Zero 561, 590, 511 Hinge Adjustment, Installation Checklist, Instructions for fastening, Step

INSTALLATION INSTRUCTIONS

2)Using the Loctite on the screws, install all 3 Chicago Screw Posts.

3)Inspect the units for level again.

4)Drill three (3) 3h6" holes (per specs in Figure 24) through both outer trims.

5)Using a '/a" drill bit, drill into the cabinetry for a pilot hole.

6)Install all six (6) Sems to the cabinetry.

Instructions for fastening

Models 501R, 501F, 550, 511,561,532,542 and 590 to cabinetry (see Figure 25):

I

17'1/1"

JI

17'/it"

L

""t

77'/8"

1)Drill three (3) 3h 6" holes (per specs in Figure 25) through both outer trims.

2)Drill a '/a" pilot hole into the cabinetry.

3)Install all six (6) Sems.

HINGE

ADJUSTMENT

Step 16

If the doors are out of adjustment, the top or bottom hinge may be adjusted by removing and discarding the two small shipping screws. See Figure 26. The top door hinges can be adjusted left to right and in or out by loosen- ing the three allen head screws. The bottom door hinge is equipped with two adjustment allen hbad screws. See Figure 27.

For adjustment, use a '/a" allen wrench to loosen screws (models 550 and 511 ex- cluded). This allows the door to move left to right or in and out.

NOTE: On Models 532, 542,

561, 501R, 501F and 590

the doors open to 130 0 •

An optional door stop kit (4-20-089-0), which allows a door opening of approxi- mately 90 0 is available. Contact your distributor.

Figure 26

Figure 27

INSTALLATION

CHECKLIST

The importance of the installa- tion of your Sub-Zero cannot be overemphasized. The proper installation of your unit is the responsibility of the selling dealer or instal- ler, The following check list should be completed by the installer to insure no part of the installation has been over- looked. Any questions or problems pertaining to the installation should be directed to the selling dealer.

o Is unit operating? If not, is unit plugged in? Is refrigeratorl freezer control on?

o Is packing material removed? (Step 6)

o Is water supply line con- nected to compression fitting? (Step 8)

IAWARNINGI

Disconnect power to unit before checking wiring connections.

o Is blocking completed? (Step 8)

o Is unit leveled properly on a solid floor? (Step 10)

o Is blocking necessary? (Step 8)

o Is drain pan installed properly? (Step 11)

o Is toe plate installed? (Step 11)

o Is grille screw back in position? (Step 12)

o Are panels installed correctly? (Step 14)

o Are doors adjusted? (Step 16)

o Does the customer under- stand the unit'soperation?

o Is the icemaker switch turned on? (Models 590, 532, 542 and 561).

Give the customer the warranty packet.

9