P R O 4 8 I N S T A L L A T I O N I N S T R U C T I O N S
WAT E R L I N E C O N N E C T I O N | L E V E L I N G T H E U N I T |
Approximately 0,9 m of 6,35 mm plastic tubing is connected to the ice maker with a preassembled 6,35 mm compression connection at the end. This tubing is located under the unit.
The water line fitting connection kit, provided with the unit, contains a 6,35 mm compression sleeve and a 6,35 mm compres- sion nut for connection to the household water line. Place the compression nut and sleeve on the water line and fasten to the connection at the end of the tubing under the unit. Do not over tighten. Check all water line fittings for leaks. Make sure that the drain pan can be installed or removed without any water line interference.
IMPORTANT NOTE: Be sure to purge the water line prior to final connection to the unit. This will remove any debris that may be present in the tubing from installing the new water line.
IMPORTANT NOTE: Let your customer know that the ice maker will not produce ice immediately, and that the first bucket of ice produced should be discarded. Allow 48 hours of ice production, before discarding the first bucket of ice.
Once the unit is in position, extend the front leveling legs down by turning the legs counterclockwise and adjust the height. The rear height adjustment can be made from the front of the base. Use a 8 mm socket to adjust the rear rollers. Turn the 8 mm hex bolt clockwise to raise the unit or counter- clockwise to lower it.
When the unit is leveled properly, or squared off, door and/or drawer adjustments are less likely to be necessary. Refer to the illustra- tion below for location of the rear roller base adjustment.
IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not to surrounding cabinetry. This could affect the operation of the unit, such as doors not closing properly.
I N S T A L L T H E K I C K P L AT E
To install, screw the kickplate to brackets attached to the inside surface of each roller base.
Rear roller base adjustment
16
