GAS INSTRUCTIONS
LEAK CHECK PREPARATION
Check That All Burner Valves Are Off
Valves are shipped in the OFF position, but you should check to be sure that they are turned off.. Check by pushing in and turning clockwise.. If they do not turn, they are off.. If they do turn continue turning them clockwise until they stop, then they are off..
mWARNING: The gas connections of your Summit® gas grill have been factory tested. We do however recommend that you leak check all gas connections before operating your Summit® gas grill.
Remove Control Panel
Parts required: Phillips screwdriver and a towel..
A)Remove the burner control knobs (1)..
B)Open both doors and place a towel on top of the doors.. This will protect the control panel and tops of the doors from getting scratched on the next step..
C)Remove the screws from the underside of the control panel with a Phillips screwdriver (2)..
D)Tilt the control panel forward and lift up and away from the grill (3).. (For Summit® models with LED features: Be careful not to break or disconnect the wires for the control panel LEDs..)
E)Place the control panel on the towel covering the door assemblies (4).. ◆
1
2
3
The grill illustrated may have slight differences than the model purchased.
4
10
