▼To Connect the Ethernet Cable
Use
TABLE
Ethernet Cable | Maximum Length | Connector |
|
|
|
Cat5e UTP | 100 meters | 8P8C |
Cat6 UTP | 100 meters | 8P8C |
|
|
|
1.Connect the ethernet cable to
2.Connect the other end of the cable to the Ethernet device.
After the ethernet cable is connected to the HBA, you are ready to apply power to the system. If power is already applied to the system, proceed to “Configuring the HBA for
▼To Apply Power
1.Verify that the HBA is securely installed in the system.
2.Verify that the correct
3.Verify that the correct ethernet cable is attached.
4.Refer to your system installation or service manual to determine how to power on the system blade.
5.Observe the
TABLE
TABLE
Green LED | Yellow LED | State |
|
|
|
On | 1 fast blink | |
On | 2 fast blinks | |
On | 3 fast blinks | |
Off | Off | |
|
|
|
14 Sun StorageTek Dual 4 Gb FC Dual GbE HBA, Emulex Installation Guide • July 2008