Sun Microsystems SG-XPCIE2FCGBE-E-Z manual Hardware Installation and Removal

C H A P T E R 2

Hardware Installation and Removal

This chapter describes the tasks required to install and remove the HBA. Refer to your system installation or service manual for detailed instructions.

This chapter contains the following topics:

■“Observing ESD and Handling Precautions” on page 9

■“Installing the Hardware” on page 10

■“Configuring the HBA for Hot-Plug Operation” on page 18

■“Removing the Hardware” on page 19

Observing ESD and Handling

Precautions

Caution – Damage to the HBA can occur as the result of careless handling or electrostatic discharge (ESD). Always handle the HBA with care to avoid damage to electrostatic sensitive components.

To minimize the possibility of ESD-related damage, use both a workstation antistatic mat and an ESD wrist strap. You can get an ESD wrist strap from any reputable electronics store or from Sun as part number #250-1007. Observe the following precautions to avoid ESD-related problems:

■Leave the HBA in its antistatic bag until you are ready to install it in the system.

■Always use a properly fitted and grounded wrist strap or other suitable ESD protection when handling the HBA, and observe proper ESD grounding techniques.

■Hold the HBA by the edge of the PCB, not by the connectors.

9