2.If an HBA is shown as unconfigured, use the cfgadm
Configuring the HBA for Hot-Plug Operation
1.Locate the green Power LED indicator near the bottom of the HBA front panel (see FIGURE
Power LED indicator status is shown in TABLE 2-6.
TABLE
LED State | Meaning | Removal Status |
|
|
|
Off | No power to the HBA | Removal is permitted, or the HBA must be |
|
| configured |
Flashing | Removal of the HBA is not permitted | |
Solid green | HBA is properly configured | Removal is not permitted |
|
|
|
2.If the green Power indicator is not illuminated, briefly press the Attention button near the bottom of the HBA front panel (see FIGURE
The green power LED will blink for approximately five seconds and then remain on, indicating that the HBA is properly configured.
3.To cancel the operation, press the Attention button again before it stops blinking.
18 Sun StorageTek Dual 4 Gb FC Dual GbE HBA, Emulex Installation Guide • July 2008