Sun Microsystems VSM GUI manual Installing a Service Tape

//jobcard JOB ‘accounting information’ //*

//EXEC PGM=IEBCOPY

//SYSPRINT DD SYSOUT=*

//SYSIN	DD DUMMY
//*
//SYSUT1	DD DSN=SMPEJCL,DISP=(OLD,KEEP),

//UNIT=3480,

//LABEL=(3,SL,EXPDT=98000),VOL=SER=VTyynn

//*

//SYSUT2 DD DSN=hlq.SMPE.JCL,DISP=(,CATLG),

//UNIT=SYSALLDA,SPACE=(TRK,(10,2,10)),

//DCB=(RECFM=FB,LRECL=80,BLKSIZE=23440)

//*

FIGURE 4-1JCL to Unload the VSM GUI Service Tape SMP/E JCL

Installing a Service Tape

Install the contents of a service tape using the following procedure.

1.Ensure that you have customized the installation jobs as described in “Set Up the SMP/E Environment and Install the Software” on page 13.

2.If necessary, modify member U1RCU.

If the cumulative service was downloaded from the StorageTek CRC, change the SMPPTFIN and SMPHOLD DDs to point to the downloaded data set names. If it is a physical tape, obtain the actual volume serial number “VTyynn” from the tape cartridge external label. If there was no HOLDDATA downloaded, then remove the SMPHOLD DD and only receive SYSMODS.

3.Run member U1RCV to RECEIVE the VSM GUI service.

4.If necessary, modify member U2APPLY.

Before running the apply job, review the output from the receive job for HOLDDATA, and follow the instructions given for each held PTF. When the requirements are met, bypass the hold condition for that held PTF in the apply job with the BYPASS parameter. Do not bypass HOLDERROR conditions.

5.Run member U2APPLY to APPLY the VSM GUI service.

312651601 • Rev A Chapter 4 Installing Service Tapes for VSM GUI 31