Preparing your espresso machine before use
1.Place the espresso machine onto a dry, stable benchtop.
2.Ensure the drip tray and grill are in place.
3.Fill the espresso machine with water. There are a couple of ways in which the water reservoir can be filled;
a)Simply lift the lid of the water reservoir at the top of the espresso machine (1) and using a jug, fill with fresh cold water or filtered water (2).
b)Alternatively the water reservoir can be removed and filled with fresh cold water. To do so, open the door on the back of the espresso machine (3) and simply slide out the water reservoir (4). Then fill with fresh cold water or filtered water (5). Replace the water reservoir firmly and shut the door.
4.Insert the power cord into a
When the green light above the ‘POWER’ button stops flashing and turns to a constant red light, this indicates that the espresso machine is heated and ready to use. The lights above the ‘MANUAL’,
single and double espresso buttons will also show a constant green light (7).
Note: Before turning on the espresso machine ensure that the steam and hot water control dials are in the OFF position.
5.Place glasses and cups on the warming plate (8).
Important: For first time use or if the machine has not been used for some time, it is important that the machine is rinsed as follows:
6.Fit the filter handle with the either the one or two cup filter basket (9). Secure the filter handle to the group head (10) (11).
7.Place a sufficiently large container under both pouring spouts (12).
8.Once the espresso machine is switched on and heated, so the light above the ‘POWER’ button is red and the lights above
the ‘MANUAL’, single and double espresso buttons show a constant green light, the espresso machine is heated and ready to use.
Tip: Remember if the ‘POWER’ light is flashing green, this indicates that the espresso machine is on and is heating up.
9.Press the ‘MANUAL’ button (13) and allow the water to run through until the water reservoir is empty.
Note: As a safety mechanism the espresso machine is programmed to automatically stop the water flow after 240mls, therefore you will need to press the ‘MANUAL’ button again to restart the water flow.
20