Sunbeam JE6400R, JE6400S, JE6400M, JE6400DG, JE6400Y manual Operating your Sunbeam Fresh Start Juicer

Models: JE6400R JE6400Y JE6400DG JE6400M JE6400S JE6400

1 24
Download 24 pages 44.69 Kb
Page 11
Image 11

Operating your Sunbeam Fresh StartJuicer

Note: The Fresh Start™ juicer should be completely assembled before use, if this is not the case see ‘Assembling your Sunbeam Fresh Start™ Juicer on page 7.

1.Ensure the control switch on the juicer is in the ‘Off’ position and insert the power cord into a 230-240V AC power outlet and turn the power ‘On’.

2.Clean fruit and vegetables thoroughly, ready for juicing.

Note: The extra large feed chute allows whole fruit and vegetables to be juiced, however some fruit and vegetables may require other preparation before juicing, such as peeling and removing stones, see ‘Juicing speed guide’ on page 10 for our recommendations.

3.Ensure that the juicer has been assembled completely and correctly, making sure that the stainless steel blade and filtering basket revolves properly before placing fruit and vegetables in the juicer.

Note: The stainless steel blade and filtering basket should be cleaned thoroughly before each use, see ‘Care and cleaning’ on page 12.

4.Place a jug or glass under the juice spout.

5.Select ‘Low’ or ‘High’ speed with the control switch. To select ‘Low’ speed push the control switch up ‘l’. To select ‘High’ speed push the control switch down ‘ll’.

For optimum juicing results ‘Low’ speed is used primarily for soft fruit and vegetables, particularly those with a high water content and ‘High’ speed is ideal for hard and fibrous fruit and vegetables. A list of fruit and vegetables commonly used for juicing and their recommended juicing speed are specified in the ‘Juicing speed guide’ on page 10.

Important: Do not operate for more than 30 seconds at a time when juicing heavy loads. None of the recipes in this manual are considered a heavy load.

6.With the juicer in operation, place the fruit and vegetables into the feed chute. Using the food pusher, guide the fruit and vegetables down the feed chute and onto the stainless steel blade.

Tip: For maximum juice extraction, guide the food pusher down the feed chute in a slow downward motion.

Important: Do not push fruit or vegetables into the feed chute with your fingers, always use the food pusher provided.

7.The juice from the fruit and vegetables will flow directly into the jug or glass and the pulp will be separated and collected in the pulp container.

Important: When juicing be aware of the level of pulp in the pulp collection container, because if the container is overfilled this can cause damage to the appliance and prevent the juicer from operating correctly.

8.When juicing is complete ensure that the juicer is switched ‘Off’ and unplugged from the power outlet.

9

Page 11
Image 11
Sunbeam JE6400R, JE6400S, JE6400M, JE6400DG, JE6400Y manual Operating your Sunbeam Fresh Start Juicer