SunBriteTV 4660HD manual Connecting with TOSLink Digital Best, Connecting with RCA Audio Analog

TV Installation – Rear Panel Connections

CONNECTING TO AN EXTERNAL AMPLIFIER OR AMPLIFIED SPEAKERS

Connecting with TOSLink Digital (Best) Connecting with RCA Audio Analog (Good)

1.Make sure the power of the TV and your receiver is turned off.

2.Obtain a Coaxial SPDIF cable, connect it to your receiver’s coaxial SPDIF digital input and the Coaxial SPDIF connection on the LINE OUT port off the back of the TV.

3.Turn on the TV and your receiver.

Please Note :

1.If you want pure digital stream for your receiver to decode, you must also configure the TV’s OSD Sound->Digital Audio Out function. Make sure the option is on Bit Stream.

2.If your receiver is making static noises when receiving Bit Stream, you must use the PCM option instead.

3.Refer to the receiver’s manual to make sure the receiver is configured to receive signals correctly from the TV

1.Make sure the power of the TV and your receiver is turned

off.

2.Obtain a 3.5mm stereo/audio cable (if your amplifier audio connection requires RCA audio out jacks you will need to obtain an 1/8” Stereo Mini Plug to RCA adapter cable). Connect it to your receiver’s audio input connection and the 3.5mm stereo/audio connection on the Analog Audio port on the back of the TV.

3.Turn on the TV and your receiver.

Please Note :

1.If you want pure digital stream for your receiver to decode, you must also configure the TV’s OSD Sound->Digital Audio Out function. Make sure the option is on Bit Stream.

2.If your receiver is making static noises when receiving Bit Stream, you must use the PCM option instead.

3.Refer to the receiver’s manual to make sure the receiver is configured to receive signals correctly from the TV

CONNECTING TO A PC

Connecting with RCA Audio Analog

Page 16

1.Make sure the power of the TV and your PC is turned off.

2.Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of your PC and the other end to the VGA port off the back of your TV.

3.Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the other end to the VGA Stereo Input port.

4.Turn on the power of the TV and your PC.

5.Use the remote control’s source button or the source button the TV to switch to VGA.

Please Note :

1.For the best results, please set your PC resolution to

1920 x 1080 at 60 Hz. Refer to the PC or graphic card’s manual for further instructions on how to set your resolution and refresh rate.

2.Refer to your PC manual for video output requirements of the video card.

3.The VGA port of the TV features a power saving mode which will automatically turn off the TV if there is no signal provided for more than 15 minutes.